Description

Milesight LoRaWAN gateways provide a user-friendly web interface for quick configuration.

If this is your first time setting up the gateway, please refer to this guide to log in to the Milesight Gateway web GUI.

• Connection via Ethernet port
• Connect via Wi-Fi

Default username: admin

Default password: password

Requirement

Milesight UG6x or UG8x Gateway

Configuration

Connection via Ethernet port

There are two types of IP addresses by default:

• 192.168.23.150 (for UG6x or UG8x with firmware version 80.0.0.62 and later)
• 192.168.1.1 (for UG8x with firmware version 87.1.0.x or earlier than 80.0.0.62)

Please refer to the back label of the gateway.

1. Connect the computer to the ETH port of the gateway with an Ethernet cable.
2. Go to Control Panel -> Network and Sharing Center -> Change adapter settings .   
3. Select Ethernet and click Properties .

4. Select Internet Protocol version 4 (TCP/IPv4) and click Use the following IP address . Then configure the default gateway as default IP of UG6x or UG8x (192.168.23.150 or 192.168.1.1).

Note: You can also select Obtain an IP address automatically if the default IP address is 192.168.1.1.

5. After saving the configurations, open a web browser on your PC (Chrome is recommended) and enter the default IP address to access the web GUI. Enter username and password, click Login .

Connect via Wi-Fi

Applicability: Wi-Fi model UG6x and UG8x.

Gateway AP mode is enabled by default without encryption.

Default IP: 192.168.1.1

1. Enable the wireless network connection on your computer, search for the hotspot “ Gateway ******” for UG6x or “ Ursalink_ ****** ” for UG8x and connect it.
2. Once logged in, open a web browser on your PC (Chrome is recommended) and enter the IP address 192.168.1.1 to access the web GUI.
3. Enter username and password, click Login .

Note: If you enter an incorrect username or password up to 5 times, the login page will be locked for 10 minutes.